Wolverine Technologies Inc., a manufacturer of vinyl siding, makes vinyl lattice panels and several other vinyl products of special interest to owners of older homes or new homes with Victorian styling. Telephone inquiries can be made by calling 40. One manufacturer, Cross Industries Inc., will refer interested persons to local dealers or sell direct if there is no dealer in an area, according to Steve Burch, a Cross spokesman.Ĭross makes several kinds of PVC (polyvinyl chloride) lattice panels in a wide range of colors.Ī brochure and more information are available by writing Cross Industries Inc., 5262 Peachtree Rd., Atlanta, Ga. I contacted two manufacturers of plastic panels, however, and they seem eager to cooperate with homeowners and do-it-yourselfers. So far, the plastic panels have been used mostly by contractors and home builders. If there's a large gap beneath the panel, add soil, then smooth it out to create a consistent space between the panel and ground.Many home centers and lumberyards stock lattice panels of pressure-treated wood, but plastic panels are more difficult to find at retail outlets because they are relatively new. If it drags on the ground, use a shovel or rake to remove some dirt from in front of the panel. Check to make sure the panel swings up and down smoothly.Use a drill/driver to screw the hinge to the porch. Slip a pry bar under the panel and raise it up tight against the porch fascia. Screw the hinges to the frames first, then set the panels in the openings under the porch.Two hinges are sufficient for a panel that's shorter than 8 feet, but use three hinges on one that's longer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |